Hazard warning flashers, Fuel cut-off switch, Jump-starting the vehicle – FORD 2013 Fusion v.1 User Manual

Page 228: Roadside emergencies

Advertising
background image

Canadian customers who need to obtain
roadside information, call
1-800-665-2006 or visit our website at
www.ford.ca.

HAZARD WARNING FLASHERS

Note: With extended use, the flashers may
run down your battery.

The hazard flasher control is
located on the instrument panel
by the radio. Use it when your

vehicle is disabled and is creating a safety
hazard for other motorists.

Press the flasher control and all front
and rear direction signals will flash.

Press the flasher control again to turn
them off.

FUEL CUT-OFF SWITCH

WARNING

Failure to inspect and if necessary
repair fuel leaks after a collision may
increase the risk of fire and serious

injury. Ford Motor Company recommends
that the fuel system be inspected by an
authorized dealer after any collision.

In the event of a moderate to severe
collision, this vehicle is equipped with a
fuel pump shut-off feature that stops the
flow of fuel to the engine. Not every impact
will cause a shut-off.

Should your vehicle shut off after a
collision, you may restart your vehicle by
doing the following:

1.

Turn the ignition off.

2. Turn the ignition to crank.
3. Turn the ignition off.
4. Turn the ignition on again to re-enable

the fuel pump.

For vehicles equipped with a push button
start system:

1.

Press the START/STOP button to
turn the ignition off.

2. Press the brake pedal and press the

START/STOP button (crank
attempt).

3. Remove your foot from the brake pedal

and press the START/STOP button
(ignition off).

4. Press the START/STOP button again

to re-enable the fuel system.

JUMP-STARTING THE VEHICLE

WARNINGS

The gases around the battery can
explode if exposed to flames, sparks,
or lit cigarettes. An explosion could

result in injury or vehicle damage.

Batteries contain sulfuric acid which
can burn skin, eyes and clothing, if
contacted.

Only use an adequate size cable with
insulated clamps.

Preparing Your Vehicle

Note: Use only a 12-volt supply to start your
vehicle.

Note: Do not disconnect the battery of the
disabled vehicle as this could damage the
vehicle's electrical system.

Park the booster vehicle close to the hood
of the disabled vehicle making sure the
two vehicles do not touch. Turn all
accessories off.

226

Roadside Emergencies

Advertising