Locks and security – FORD 2012 F-150 Raptor v.1 User Manual

Page 138

Advertising
background image

For optional message center:

1. At the main menu screen select SETTING then MYKEY by pressing
OK or the right arrow key.

2. Press OK to select CREATE MYKEY.

3. Hold OK as prompted until you see MARK THIS KEY AS RESTRICTED.

MyKey

௡ is successfully programmed. Make sure you label it so you can

distinguish it from the admin keys. Note: To program the optional
settings go to Step 2 in the Programming MyKey

optional settings

section. If your vehicle is equipped with remote start, see the Using
MyKey

with remote start systems section.

Note: The MyKey

௡ can be cleared within the same key cycle that it was

created, otherwise a standard key (administrator key) is required to
clear the MyKey

௡ programming. To clear all MyKeys௡ go to Step 2 in the

Clear MyKey

௡ section.

Programming MyKey

optional settings

To program the optional settings, use the message center buttons to do
the following:

For standard message center:

1. Press SETUP until RESET FOR MYKEY SETTINGS is displayed.

2. Press and release the RESET button to display MyKey

௡ setup menus.

The first menu shown is:

MYKEY MAX MPH <80 MPH> OFF

3. If you don’t want to change the maximum speed setting, press the
SETUP button to display the next menu. The remaining menus appear as
follows with the default settings shown:

MYKEY MPH TONES 45 55 65 <OFF>
MYKEY VOLUME LIMIT <ON> OFF
MYKEY ADVTRAC CTRL ON <OFF>.

4. On any of the menus press RESET to highlight your choice with the
<…>.

5. Press SETUP to enter your choice. The next optional setting will be
displayed.

6. Repeat Steps 4 and 5 until you are done changing the optional settings.

Locks and Security

138

2012 F-150 (f12)
Owners Guide, 1st Printing
USA
(fus)

Advertising
This manual is related to the following products: