FORD 2012 Flex v.2 - Manual (Page 127)

3. Follow Steps 1-4 in the Create a MyKey
௡ section.
Note: For all vehicles, the number of MYKEY(S) PROGRAMMED or
ADMIN KEYS PROGRAMMED that is displayed in the MyKey
௡ system
status menus will include the remote start system as an additional key in
the total count. See the Check MyKey
௡ system status section.
Note: For all vehicles with remote start installed, it is possible to
program all original vehicle keys as MyKeys
௡, in which case, you will
need to use your remote start system to reset all MyKeys
௡ as admin keys
by doing the following:
1. Enter the vehicle, close all doors.
2. Remote start the vehicle using your remote start fob.
3. Follow Steps 1-4 in the Clear MyKey
௡ section.
Troubleshooting
Condition Potential Causes
Can’t create a
MyKey
௡
• Key in the ignition is already a MyKey௡
• Key in the ignition is the last remaining admin
key (there always has to be at least one admin
key)
• SecuriLock௡ passive anti-theft system is
disabled or in unlimited mode
• Vehicle has been started using a remote start
system that is programmed as MyKey
௡. Refer to
Using MyKey
௡ with remote start systems
section.
Cannot program the
MyKey
௡ optional
settings
• Key in the ignition is a MyKey௡
• No MyKeys௡ are programmed to the vehicle.
Refer to Create a MyKey
௡ section
• Vehicle has been started using a remote start
system that is programmed as MyKey
௡. Refer to
Using MyKey
௡ with remote start systems
section.
Locks and Security
126
2012 Flex (471)
Owners Guide, 2nd Printing
USA (fus)