Tires, wheels and loading – FORD 2012 Transit Connect User Manual

Page 161

Advertising
background image

3. Cycle the ignition to the on
position with the engine off.

4. Turn the hazard flashers on then
off three times. This must be
accomplished within 10 seconds.

If the reset mode has been entered successfully, the horn will sound
once and the TPMS indicator

will flash. If this does not occur, please

try again starting at step 2.

If after repeated attempts to enter the reset mode, the horn does not
sound and the TPMS indicator

does not flash, seek service from your

authorized dealer.

5. Train the TPMS sensors in the tires using the following TPMS reset
sequence starting with the left front tire in the following clockwise
order:
• Left front (Driver’s side front tire)
• Right front (Passenger’s side front tire)
• Right rear (Passenger’s side rear tire)
• Left rear (Driver’s side rear tire)
6. Remove the valve cap from the valve stem on the left front tire;
decrease the air pressure until the horn sounds.

Note: The single horn chirp confirms that the sensor identification code
has been learned by the module for this position. If a double horn is
heard, the reset procedure was unsuccessful, and must be repeated.

7. Remove the valve cap from the valve stem on the right front tire;
decrease the air pressure until the horn sounds.

8. Remove the valve cap from the valve stem on the right rear tire;
decrease the air pressure until the horn sounds.

Tires, Wheels and Loading

161

2012 Transit Connect (tst)
Owners Guide, 1st Printing
USA
(fus)

PAGE POSITION: 161

JOB: @zeta.tweddle.com/ford_pdm/ford/own2002/835536-en-tst/og

pubnum:

Advertising