FORD 2011 Crown Victoria v.1 - Manual (Page 82)

• To release the trunk, enter the factory-set code or personal code
(driver door unlocks) and press 5
• 6 within five seconds.
After the factory-set code or personal code has been entered, you can
unlock all doors (press 3
• 4) and release the trunk (press 5 • 6) as
long as the controls are pressed within five seconds of each other.
Locking doors with the keyless entry system
It is not necessary to enter the factory-set code prior to locking all doors.
To lock the doors, press 7
• 8 and press 9 • 0 at the same time.
Note: The doors will not lock if the driver door is ajar.
Anti-scan feature
If the wrong code has been entered seven times (35 consecutive button
presses), the keypad will go into an anti-scan mode. This mode disables
the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the
control on the remote entry transmitter.
• the ignition is turned to the on position.
SECURILOCK ா PASSIVE ANTI-THEFT SYSTEM
SecuriLock
௡ passive anti-theft system is an engine immobilization
system. This system is designed to help prevent the engine from being
started unless a coded key programmed to your vehicle is used. The
use of the wrong type of coded key may lead to a “no-start” condition.
This device complies with part 15 of the FCC rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation.
Locks and Security
82
2011 Crown Victoria (cro)
Owners Guide, 1st Printing
USA (fus)