Shifting between modes, Shifting between 2h and 4a or 4h, Driving – FORD 2010 Expedition v.1 User Manual

Page 314

Advertising
background image

dry pavement. This position is only intended for severe winter or
off-road conditions, such as deep snow, ice or shallow sand.

4L (4X4 LOW) provides electronically locked four-wheel drive when

extra power at reduced speeds is required. The message center will
display “4X4 LOW” when this position is selected. This position is not
recommended for use on dry pavement. Use this position for off-road
low-speed operation or when extra power is required, such as climbing
steep grades, going through deep sand or pulling a boat out of the
water.

Note: If your vehicle is equipped with AdvanceTrac

௡ with RSC௡, the

AdvanceTrac

௡ with RSC௡ system will automatically turn off the stability

enhancement feature when you shift the Control Trac four-wheel drive
system into 4L (4X4 LOW). The brake traction enhancement feature will
still be enabled.

The AdvanceTrac

௡ with RSC௡ stability enhancement system can be

turned off manually by pressing the AdvanceTrac

௡ with RSC௡ button

(refer to AdvanceTrac

with Roll Stability Control™ (RSC) Stability

Enhancement System in this chapter) while operating in 2H, 4A or 4H
while driving in deep sand, very deep snow or more strenuous off-road
maneuvers. This will disable the engine management feature, allowing
the vehicle to maintain full power and enhanced momentum through the
obstacle.

WARNING: Utility and four-wheel drive vehicles are not
designed for cornering at speeds as high as passenger cars any

more than low-slung sports cars are designed to perform satisfactorily
under off-road conditions. Avoid sharp turns or abrupt maneuvers in
these vehicles.

Note: The Control Trac selector knob should not be changed while the
rear wheels are slipping.

Shifting between modes

Shifting between 2H and 4A or 4H

Move the control from 2H to the 4A or 4H position at any forward speed
or at a stop. The message center may display 4X4 SHIFT IN
PROGRESS
during the system shift. The message center will then
display “4X4 AUTO” if 4A is selected or “4X4” if 4H is selected. The
message center will momentarily display

Љ4X2Љ if 2H is selected.

Driving

314

2010 Expedition (exd)
Owners Guide (own2002), 1st Printing
USA
(fus)

Advertising