Steering, Driving – FORD 2010 F-150 v.1 User Manual

Page 285

Advertising
background image

Disabling trailer sway control

Trailer sway control can be disabled during any key cycle. See trailer
sway control under the Message center in the Instrument Cluster
chapter. Note that regardless of chosen enable state, trailer sway control
will be re-enabled at each new key cycle.

WARNING: Turning off trailer sway control increases the risk of
loss of vehicle control, serious injury, or death. Ford does not

recommend disabling this feature except in situations where speed
reduction may be detrimental (e.g., hill climbing), the driver has
significant trailer towing experience, and can control trailer sway and
maintain safe operation.

STEERING

To help prevent damage to the power steering system:
• Never hold the steering wheel at its furthest turning points (until it

stops) for more than a few seconds when the engine is running.

• Do not operate the vehicle with a low power steering fluid level

(below the MIN mark on the reservoir).

• Some noise is normal during operation. If the noise is excessive, check

for a low power steering fluid level before seeking service by your
authorized dealer.

• Heavy or uneven steering efforts may be caused by a low power

steering fluid level. Check for a low power steering fluid level before
seeking service by your authorized dealer.

• Do not fill the power steering fluid reservoir above the MAX mark on

the reservoir.

If the power steering system breaks down (or if the engine is turned
off), you can steer the vehicle manually, but it takes more effort.

If the steering wanders or pulls, check for:
• an improperly inflated tire
• uneven tire wear
• loose or worn suspension components
• loose or worn steering components
• improper steering alignment
A high crown in the road or high crosswinds may also make the steering
seem to wander/pull.

Driving

285

2010 F-150 (f12)
Owners Guide, 1st Printing
USA
(fus)

Advertising