Driver controls – FORD 2009 F-550 v.1 User Manual

Page 135

Advertising
background image

to clean the DPF. This will continue to be displayed until an adequate
drive cycle is completed. This message is NORMAL. Note:
Power-Take-Off (PTO) and/or Stationary Elevated Idle (SEIC) must be
disabled in order to initiate Diesel Particulate Filter (DPF) cleaning.

CLEANING EXHAUST FILTER (Diesel engine only) — Displays
continuously when the vehicle has entered the cleaning mode normally;
or when cleaning the filter after a DRIVE TO CLEAN EXHAUST FILTER
message was previously displayed. When this message is displayed
various engine actions will raise the exhaust temperature in the DPF to
clean the exhaust filter. After the exhaust filter is cleaned, the exhaust
temperature will fall back to normal levels. This message is NORMAL.

WARNING: When the CLEANING EXHAUST FILTER message
appears in the message center do not park near flammable

materials, vapors and structures until filter cleaning is complete.

EXHAUST FILTER DRIVE COMPLETE (Diesel engine only)
Displayed when the vehicle has completed the adequate drive cycle to
clean the DPF. This message is NORMAL.

WARNING: Do not park, idle, or drive your vehicle in dry grass
or other dry ground cover. The emission system heats up the

engine compartment and exhaust system, which can start a fire.

OIL LIFE CHANGE SOON (Gas engine only) — Displayed when the
engine oil life remaining is 5 percent or less. When oil life left is between
5% and 0%, the ENGINE OIL CHANGE SOON message will be displayed.

OIL CHANGE REQUIRED (Gas engine only) — Displayed when the
oil life left reaches 0%, the OIL CHANGE REQUIRED message will be
displayed. OIL LIFE OK displays after you have changed the oil.

2009 F-250/350/450/550 (f23)
Owners Guide, 1st Printing
USA
(fus)

Driver Controls

135

Advertising
This manual is related to the following products: