Oil life, Units (english/metric), Autolamp delay – FORD 2008 Escape v.1 User Manual

Page 69: Driver controls

Advertising
background image

3. Liftgate and glass

4. DTE/Fuel level

Oil life

An oil change is required whenever indicated by the message center.
USE ONLY RECOMMENDED ENGINE OILS.

To reset the oil monitoring system to 100% after each oil change
[approximately 7,500 miles (12,000 km) or 12 months] perform the
following:

1. Press and release the SETUP
control to display “OIL LIFE =
XXX% HOLD RESET = NEW”.

2. Press and hold the RESET
control for 2 seconds and release.
Oil life is set to 100% and “OIL LIFE
SET TO 100%” is displayed.

3. While “OIL LIFE SET TO 100%”
is displayed, if a lower oil life start
value is desired, press and release the RESET control to reduce the start
value. Each press of the RESET control reduces the value by 10 percent.

Note: Oil life start value of 100% equals 7,500 miles (12,000 km) or 12
months. For example, setting oil life start value to 60% sets the oil life
start value to 4,500 miles (7,200 km) and 108 days.

Units (English/Metric)

1. Select this function from the
SETUP menu for the current units
to be displayed.

2. Press the RESET control to
change from English to Metric.

Autolamp delay

This feature keeps your headlights on for up to three minutes after the
ignition is switched off.

2008 Escape (204)
Owners Guide (post-2002-fmt)
USA
(fus)

Driver Controls

69

Advertising