Safety belt extension assembly, Seating and safety restraints – FORD 2007 E-450 v.1 User Manual

Page 75

Advertising
background image

While the design allows you to deactivate your BeltMinder

௡, this

system is designed to improve your chances of being safely

belted and surviving an accident. We recommend you leave the
BeltMinder

௡ system activated for yourself and others who may use the

vehicle. To reduce the risk of injury, do not deactivate/activate the
BeltMinder

௡ feature while driving the vehicle.

1. Turn the ignition switch to the ON position. (DO NOT START THE
ENGINE.)

2. Wait until the safety belt warning light turns off. (Approximately
1 minute)
• Step 3 must be completed within 50 seconds after the safety belt

warning light turns off.

3. At a moderate speed, buckle then unbuckle the safety belt 9 times,
ending with the safety belt in the unbuckled state.
• After Step 3 is complete, the safety belt warning light will be turned

on for 3 seconds.

• Beltminder௡ will automatically exit programming mode without

changing its enable status if Step 4 does not occur within 10 seconds
of the end of Step 3.

4. Within 10 seconds of the light turning on, at a moderate speed, buckle
then unbuckle the safety belt.
• This will disable the BeltMinder௡ feature for that seating position if it

is currently enabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds.

• This will enable the BeltMinder௡ feature for that seating position if it

is currently disabled. As confirmation, the safety belt warning light will
flash 4 times per second for 3 seconds, followed by 3 seconds with the
light off, then followed by the safety belt warning light flashing 4 times
per second for 3 seconds again.

5. After receiving confirmation, the deactivation/activation procedure is
complete.

Safety belt extension assembly

If the safety belt is too short when fully extended, there is a 8 inch
(20 cm) safety belt extension assembly that can be added (part number
611C22). This assembly can be obtained from an authorized dealer.

Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on

2007 Econoline (eco)
Owners Guide (post-2002-fmt)
USA
(fus)

Seating and Safety Restraints

75

Advertising
This manual is related to the following products: