FORD 2007 Escape v.1 - Manual (Page 216)

• guide the jack bottom first in the
trim opening and position in the
bracket (3),
• secure the retention clip on the
upper part of the jack (2), and
• close the thumbscrew (1).
Make sure the jack is fastened so it
does not rattle when you drive.
Non-cargo management system
(if equipped):
• Reclip the tools onto the jack
making sure that the tools are
fully contained by the clips as
shown.
• Reinstall the jack in the pocket
with the left side first, then snap
the right side down.
• Ensure that the hold-strap
contains the jack and tools before snapping the buckle.
• Ensure that the jack and tools are oriented as illustrated.
Stowing the flat/spare tire
Note: Failure to follow spare tire stowage instructions may result in
failure of cable or loss of spare tire.
If you are stowing a tire that requires reattaching it to the
vehicle with a tether, perform these steps first, then proceed with
the steps following.
2007 Escape (204)
Owners Guide (post-2002-fmt)
USA (fus)
Roadside Emergencies
216