FORD 2006 Crown Victoria v.2 - Manual (Page 92)

To store a third personal code:
1. Enter the factory set code.
2. Within five seconds press 1
• 2 on the keypad to enter the
programming mode.
3. Enter a third personal 5-digit code. Each number must be entered
within five seconds of each other.
4. Press 5
• 6 (or 7 • 8, or 9 • 0, or wait five seconds) to store the third
personal code.
5. The doors will again lock then unlock to confirm programming of the
new code.
Tips:
• Do not set a code that uses five of the same number.
• Do not use five numbers in sequential order.
• The factory set code will work even if you have set your own personal
code.
• If you set a second personal code it will erase your first personal code.
Erasing personal code
To erase all of the personal entry codes programmed to a vehicle:
1. Enter the factory-set code.
2. Press and release 1
• 2 within 5 seconds of step 1.
3. Press and hold 1
• 2 for two seconds. All of the vehicle doors will lock
and then unlock to confirm erasure.
Unlocking the doors and releasing the trunk with the keyless entry
system
To unlock the driver door, enter either the factory-set code or personal
code (each digit pressed within 5 seconds of prior digit). The interior
lamps will illuminate.
• To unlock all doors, enter the factory-set code or personal code
(driver door unlocks) and press 3
• 4 within five seconds.
• To release the trunk, enter the factory-set code or personal code
(driver door unlocks) and press 5
• 6 within five seconds.
After the factory-set code or personal code has been entered, you can
unlock all doors (press 3
• 4) and release the trunk (press 5 • 6) as
long as the controls are pressed within 5 seconds of each other.
Locking doors with the keyless entry system
It is not necessary to enter the factory-set code prior to locking all doors.
To lock the doors, press 7
• 8 and press 9 • 0 at the same time. Note:
The doors will not lock if the driver door is ajar.
2006 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA (fus)
Locks and Security
92