FORD 2005 Crown Victoria v.1 - Manual (Page 71)

Erasing HomeLink ா buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink
௡ buttons until the
indicator light begins to
flash-after 20 seconds. Release
both buttons. Do not hold for
longer that 30 seconds.
HomeLink
௡ is now in the train (or
learning) mode and can be programmed at any time beginning with step
2 in the “Programming” section.
Reprogramming a single HomeLink ா button
To program a device to HomeLink
௡ using a HomeLink௡ button previously
trained, follow these steps:
1. Press and hold the desired HomeLink
௡ button. Do NOT release the
button.
2. The indicator light will begin to flash after 20 seconds. Without
releasing the HomeLink
௡ button, follow step 2 in the “Programming”
section.
For questions or comments, contact HomeLink
௡ at www.homelink.com
or 1–800–355–3515.
ELECTRONIC MESSAGE CENTER (IF EQUIPPED)
The electronic message center only
works when the ignition is in the
ON position.
The message center allows you to:
• see problems such as door ajar,
air suspension, trunk ajar, washer
fluid low
• see how many kilometers/miles
you can drive before running out
of fuel
• see when overdrive has been deactivated
• monitor the average fuel economy
CHECK
TRUNK AJAR LTR/100 km
AIR SUSPENSION
OVERDRIVE OFF
DOOR
AJAR
LOW
WASHER
FLUID
DISTANCE
TO EMPTY
TRIP
A
AVG FUEL
ECONOMY
TRIP
B
AVG
SPEED
km
MILES
/GAL
REVIEW COPY
2005 Crown Victoria (cro), Owners Guide (post-2002-fmt) (own2002),
Market: USA_English (fus)
Driver Controls
71