Energy management retractors, Seating and safety restraints – FORD 2005 F-150 v.3 User Manual

Page 112

Advertising
background image

3. Insert the belt tongue into the proper buckle for your seating position
until you hear a snap and feel it latch.

4. Make sure the tongue is securely fastened to the buckle by pulling on
the tongue.

The lap belt should fit snugly and as low as possible around the
hips, not across the waist.

Front and rear seat occupants, including pregnant women,
should wear safety belts for optimum protection in an accident.

Each seating position in your vehicle has a specific safety belt
assembly which is made up of one buckle and one tongue that

are designed to be used as a pair. 1) Use the shoulder belt on the
outside shoulder only. Never wear the shoulder belt under the arm. 2)
Never swing the safety belt around your neck over the inside shoulder.
3) Never use a single belt for more than one person.

While you are fastened in the seat belt, the combination lap/shoulder belt
with a cinch tongue adjusts to your movement. However, if you brake
hard, turn hard, or if your vehicle receives an impact of 8 km/h (5 mph)
or more, the safety belt will become locked and help reduce your
forward movement.

Energy management retractors

Your vehicle has a seat belt system equipped with energy management
retractors at the driver and front outboard passenger seating positions.

An energy management retractor is a device which pays out webbing in a
controlled manner. This feature is designed to help further reduce the
risk of force-related injuries to the occupant.

Seat belt systems equipped with an energy management retractor must
be replaced if they were in use during a frontal collision which resulted
in deployment of the frontal air bags. Refer to the Safety belt
maintenance
section in this chapter.

2005 F150 (f12)
Owners Guide (post-2002-fmt)
USA_English
(fus)

Seating and Safety Restraints

112

Advertising