Sounding a panic alarm, Locks and security – FORD 2005 F-150 v.3 User Manual

Page 87

Advertising
background image

The

(lock) and

(unlock) features will work again after:

• a door has become ajar,
• the ignition is turned to the 3 (ON) position, or
• using the UNLOCK

control on your remote entry transmitter or

unlocking via the keyless entry keypad.

Deactivating/activating power door lock/unlock disable feature

All vehicle doors must be closed before beginning the procedure. You
must complete Steps 1–5 within 30 seconds, or the procedure will have
to be repeated. If the procedure needs to be repeated, you must wait a
minimum of 30 seconds to begin again.

1. Turn the ignition to the 3 (ON) position, then press the

button

three times.

2. Turn the ignition to the 1 (OFF/LOCK) position, then press the
button three times.

3. Turn the ignition to the 3 (ON) position; the horn will chirp to
indicate the driver configuration mode has been activated. Within five
seconds, press the

control two times. Note: After turning the ignition

to the 3 (ON) position, two horn chirps should be heard, indicating that
the system has been disabled. Conversely, two horn chirps followed by a
honk will indicate that the system is enabled.

4. Within five seconds, press the

control two times. Note: One horn

chirp should be heard, indicating the system has been disabled.
Conversely, a horn chirp followed by a honk will indicated the system is
enabled. Pressing the power door

button two times again will turn the

feature ON if it was previously OFF, or OFF if it was previously ON.
Every two consecutive presses of the

button after successfully

entering the configuration mode will change the enable/disable condition
of the feature.

5. Turn the ignition to the 1 (OFF/LOCK) position to exit programming.
Note: After exiting the driver configuration mode, the horn will chirp
once to indicate a feature has been activated/deactivated.

Sounding a panic alarm

Press

to activate the alarm. Press again or turn the ignition to 2

(ACCESSORY) or 3 (ON) to deactivate.

Note: The panic alarm will only operate when the ignition is in the 1
(OFF/LOCK) position.

2005 F150 (f12)
Owners Guide (post-2002-fmt)
USA_English
(fus)

Locks and Security

87

Advertising