Locks and security – FORD 2004 Explorer v.1 User Manual

Page 90

Advertising
background image

7. Turn the ignition to OFF. The horn will chirp once to confirm the
procedure is complete.

Keyless entry key pad procedure

1. Turn the ignition to the OFF position.

2. Close all the doors, the liftgate and liftgate window.

3. Enter 5–digit entry code

4. Press and hold the 7

• 8. While holding the 7 • 8 press the 3 • 4.

5. Release the 3

• 4.

6. Release the 7

• 8.

The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.

Message center procedure

For information on activating/deactivating the autolock feature using the
vehicle’s message center (if equipped), refer to Message center
information in the Driver controls chapter.

SECURILOCK

ி PASSIVE ANTI-THEFT SYSTEM

SecuriLock

௢ passive anti-theft system is an engine immobilization

system. This system is designed to prevent the engine from being started
unless a coded key programmed to your vehicle is used. The use of
the wrong type of coded key may lead to a “no-start” condition.

Your vehicle comes with two coded keys; additional coded keys may be
purchased from your dealer. The dealer can program your spare keys to
your vehicle or you can program the keys yourself. Refer to
Programming spare keys for instructions on how to program the coded
key.

Note: The SecuriLock

௢ passive anti-theft system is not compatible with

non-Ford aftermarket remote start systems. Use of these systems may
result in vehicle starting problems and a loss of security protection.

Note: Large metallic objects, electronic devices that are used to
purchase gasoline or similar items, or a second coded key on the same
key chain may cause vehicle starting issues. You need to prevent these
objects from touching the coded key while starting the engine. These
objects will not cause damage to the coded key, but may cause a
momentary issue if they are too close to the key when starting the
engine. If a problem occurs, turn the ignition off, remove all objects on
the key chain away from the coded key and restart the engine.

2004 Explorer (exp)
Owners Guide (post-2002-fmt)
USA English
(fus)

Locks and Security

90

Advertising