Locks and security – FORD 2003 Escape v.1 User Manual

Page 72

Advertising
background image

5. Turn the ignition from the 1 (LOCK) position to the 3 (ON) position.
Keep the ignition in the 3 (ON) position for at least one second, but no
more than 10 seconds.

6. Turn the ignition to the 1 (LOCK) position and remove the second
previously programmed coded key from the ignition.

7. Within twenty seconds of removing the previously programmed coded
key,
insert the new unprogrammed key into the ignition.

8. Turn the ignition from the 1 (LOCK) position to the 3 (ON) position.
Keep the ignition in the 3 (ON) position for at least one second but not
more than 10 seconds.

9. Remove the newly programmed coded key from the ignition.

If the key has been successfully programmed it will start the vehicle’s
engine and the theft indicator light will illuminate for three seconds and
then go out.

If the key was not successfully programmed, it will not start your
vehicle’s engine and the theft indicator light will flash on and off, or stay
on for more than three seconds. If failure repeats, bring your vehicle to
your dealer to have the new key(s) programmed.

To program additional new unprogrammed key(s), repeat this procedure
from step 1 for each additional key.

PERIMETER ALARM SYSTEM (IF EQUIPPED)

The perimeter anti-theft system will help prevent your vehicle from
unauthorized entry.

If there is any potential perimeter anti-theft problem with your vehicle,
ensure ALL remote entry transmitters are taken to the dealership to
aid in troubleshooting.

Arming the system

When armed, this system will respond if unauthorized entry is
attempted. When unauthorized entry occurs, the system will flash the
headlamps, parking lamps and fog lamps, and will sound the horn.

The system is ready to arm whenever key is removed from the ignition.
Either of the following actions will prearm the alarm system:
• Press the

control on the remote entry transmitter.

• Lock the doors with the key in the key cylinder.
• Open a door and press the power door lock control to lock all the

doors, and then close the door.

Locks and Security

72

Advertising