Driver controls – FORD 2003 Explorer v.2 User Manual

Page 72

Advertising
background image

LOW WASHER FLUID LEVEL. Indicates the washer fluid reservoir is
less than one quarter full. Check the washer fluid level. Refer to
Windshield washer fluid in the Maintenance and specifications
chapter.

CHECK ADVANCETRAC

(if equipped). Displayed when the

AdvanceTrac

௢ system is not operating properly. If this message is

displayed on the message center the AdvanceTrac

௢ system will be

partially operable. If this warning stays on while the engine is running,
contact your dealer for service as soon as possible. For further
information, refer to AdvanceTrac

stability enhancement system in

the Driving chapter.

ADVTRAC OFF T/C ON. Displayed on 4x4 vehicles only when 4x4 Low
Range is selected. In this mode, the stability enhancement portion of the
AdvanceTrac

௢ is disabled, but the traction enhancement feature remains

enabled. For further information, refer to AdvanceTrac

stability

enhancement system in the Driving chapter.

DOOR AJAR. Displayed when a door or liftgate is not completely
closed.

CHANGE OIL SOON/OIL CHANGE REQUIRED. Displayed when the
engine oil life remaining is 5 percent or less. When oil life left is between
5% and 0%, the CHANGE OIL SOON message will be displayed. When oil
life left reaches 0%, the OIL CHANGE REQUIRED message will be
displayed.

An oil change is required whenever indicated by the message center.
USE ONLY RECOMMENDED ENGINE OILS.

To reset the oil monitoring system to 100% after each oil change
[approximately 8,000 km (5,000 miles) or 180 days] perform the
following:

1. Press the SETUP control to
access the System Check function.

2. Press and release the RESET
control to display “OIL LIFE XX%
HOLD RESET NEW”.

Driver Controls

72

Advertising