FORD 2003 Mustang v.5 - Manual (Page 35)

• (4) Horizontal
reference line
2. Measure the height
from the center of your
headlamp to the ground
and mark a 2.4 meter (8
foot) horizontal
reference line on the
vertical wall or screen at this height (a piece of
masking tape works well). The center of the lamp is
marked by a 3.0 mm circle on the headlamp lens.
3. Turn on the low beam headlamps to illuminate the
wall or screen and open the hood.
4. On the wall or screen
you will observe a light
pattern with flat edges
at the top of the beam
pattern. If the flat edges
are not at the horizontal
reference line, the beam will need to be adjusted.
5. Locate the vertical
adjuster on each
headlamp, then use a 6
mm allen wrench or
screwdriver to adjust the
headlamp up or down.
6. HORIZONTAL AIM
IS NOT REQUIRED
FOR THIS VEHICLE AND IS NON-ADJUSTABLE.
7. Close the hood and turn off the lamps.
TURN SIGNAL CONTROL
• Push down to
activate the left turn
signal.
• Push up to activate
the right turn signal. OFF
HI
LO
2003 Mustang (mus)
Owners Guide (post-2002-fmt)
USA English (fus)
Lights
35