FORD 2003 Windstar v.2 - Manual (Page 66)

Single/Dual Display Mode
1. Select this function from the
SETUP menu for the current display
mode.
2. Press the RESET control to
change from the Single to the Dual
display.
Temporary display mode (if equipped)
These messages will display for 4 seconds when speed control is ON,
refer to Speed control in this chapter for operation.
“SPEED CONTROL READY” will be
displayed when the speed control
ON button is pressed.
“SPEED CONTROL OFF” will be
displayed when the speed control
OFF button is pressed.
“SPEED CONTROL SET” will be
displayed when either the speed
control SET or COAST buttons are
pressed.
“SPEED CONTROL CANCELLED”
will be displayed when the brake
pedal pressed.
System warnings
System warnings alert you to possible problems or malfunctions in your
vehicle’s operating systems.
In the event of a multiple warning situation, the message center will
cycle the display to show all warnings by displaying each one for 4
seconds.
The message center will display the last selected feature if there are no
more warning messages. This allows you to use the full functionality of
Driver Controls
66