FORD 2003 Windstar v.2 - Manual (Page 76)

To remove the cross-bar assembly:
1. Loosen the thumbwheel at both
ends of the cross-bar (both
cross-bars are adjustable).
2. Slide cross-bar to the end of the
side rails.
3. Use a long, flat object to depress
the tongue on both ends of the side
rails and slide the cross-bar off the
end.
To install the cross-bar assembly:
Note: Ensure that both cross-bar
assemblies are installed with the
arrow, located on the bottom of the
cross-bar end, facing towards the
front of the vehicle.
1. While depressing the tongue in
the side rails, slide the front
cross-bar onto the side rails aligning
the leg studs and adjusting knob
into the side rails, do not tighten.
2. After alignment is made on the
cross-bar, tighten the thumbwheel at both ends of the cross-bar. Repeat
steps 1 and 2 to install the other cross-bar.
Note: When the cross-bars are not in use, move the cross-bars to the
back of the roof rack for optimum wind noise.
Driver Controls
76