FORD 2002 Explorer Sport Trac v.1 - Manual (Page 85)

The factory-set code is located:
• on the owner’s wallet card in the glove compartment
• marked on the computer module
• or at your dealer
When pressing the controls on the keyless entry keypad, press the
middle of the controls to ensure a good activation.
Programming your own personal entry code
1. Enter the factory-set code (keypad will illuminate when pressed).
2. Press the 1/2 control within five
seconds of step 1.
3. Enter your personal 5 digit code.
Enter each digit within five seconds
of the previous one.
Do not set a code that includes five of the same number or presents
them in sequential order. Thieves can easily figure out these types of
codes.
Your personal code does not replace the permanent code that the
dealership gave you. You can use either code to unlock your vehicle. If a
second personal code is entered, the module will erase the first personal
code in favor of the new code.
If you wish to erase your personal code, use the following instructions:
Erasing personal code
1. Enter the factory-set code.
2. Press and hold 1/2 for two
seconds within five seconds of step
1.
The system will now only respond
to the factory-set code.
1 2 3 4 5 6 7 8 9 0
1 2 3 4 5 6 7 8 9 0
Controls and features
85