FORD 2002 Windstar v.2 - Manual (Page 101)

5. doors closed (driver and passenger side). This message can only be
reset by closing the door(s). If the RESET control is pressed, PLEASE
CLOSE DOOR will be displayed.
6. rear liftgate status
7. exterior lamps (headlamps, front turn, brake, tail and cornering/side
repeater lamp status)
8. Traction Control
௢ or AdvanceTrac௢ (if equipped)
9. fuel level
10. distance to empty
Single/Dual Display Mode
1. Select this function from the
SETUP menu for the current display
mode.
2. Press the RESET control to
change from the Single to the Dual
display.
Temporary display mode (if equipped)
These messages will display for 4 seconds when speed control is ON,
refer to Speed control in this chapter for operation.
“SPEED CONTROL READY” will be
displayed when the speed control
ON button is pressed.
“SPEED CONTROL OFF” will be
displayed when the speed control
OFF button is pressed.
“SPEED CONTROL SET” will be
displayed when either the speed
control SET or COAST buttons are
pressed.
Driver Controls
101