FORD 2000 Contour - Manual (Page 207)

Maintenance and care
207
Reinstalling the headlamp
assembly
The gasket lining must be seated
properly around the lamp assembly
when reinstalling.
All bulb connectors must be
correctly connected.
Install in the reverse order.
Headlamps – low beam
Disconnect the electrical connector
and replace the bulb.
Do not touch the glass part of the
bulb and pay attention to the tab
guides when replacing.
Headlamp alignment
Check the headlamp alignment
after each replacement of a bulb.
Refer to Aiming the headlamps.
Headlamps – high beam
Replacement instructions are the
same as for the low beam
headlamp.
31CMCen 17.6.99 11:15 Uhr Seite 207