FORD 1999 Windstar - Manual (Page 89)

Closing the PSD
With the ON/OFF control in the ON position, either sliding door can be
closed by:
• operating the remote transmitter. Refer to Remote Entry System in
this chapter.
• pushing and releasing the overhead console right hand or left hand
control
• pushing and releasing the right hand or left hand second row
passenger control
• manually rolling the door several inches towards the closed position
and release
The door will close completely and latch using these options.
With the ON/OFF control in the OFF position, either sliding door can be
closed by pulling the inside or outside handle and sliding the door all the
way forward to the latched position manually.
Safety/Obstructions
If anything obstructs the Power Sliding Door while it is closing, the door
will automatically reverse to the open position, provided it meets
sufficient resistance.
Resetting the PSD
The power sliding door may operate incorrectly or not at all because of
the following condition:
• a low voltage or dead battery
• disconnecting the battery
• if the PSD fuse (fuse #6) is removed or blown. Refer to Fuses and
relays in the Roadside emergencies chapter.
If any of these conditions occur, reset the PSD by:
1. Check to see if power sliding door is unlocked and securely closed.
2. Make sure vehicle is in (P) Park.
3. Push the power door control on the overhead console to open the
door.
4. Wait five (5) seconds and close the door by pressing the power door
control on the overhead console.
5. Wait five (5) seconds and repeat Steps 3 and 4 and go on to step 6.
Controls and features
89