Hella FF 100 Fog - Manual (Page 10)

10
For mounting pendant/upright
above or below bumper. Lamp
should not vibrate or extend above
the bonnet and must be attached
symmetrically.
1. Determine mounting position
and mark mounting points.
2. Drill pilot hole with 3 mm dia. bit
and then bore out to 6,5 mm.
Protect drilled metal parts with rust
protection paint.
Tools required:
Mounting steps:
• Ruler
• Combination pliers
• 10 mm open end or box
wrench
• 5 mm Allen Keys
• Drill with 3/ 6,5/ 12 mm dia. bits
• Insulating tape
3. Remove lamp set, press rubber
grommet in from inside and install
stabilization ring (Fig.1; 2).
4. Preinstall bracket (Fig. 3) and
assemble with housing depending
on desired position (Fig. 4).
Tighten bolts hand-tight.
1. Two-point mount
2. Wiring harness with relay
3. Protective grille
Accessories, see Fig. page 6
(not included with kit)
Please Note:
For a satisfactory paint finish,
please have the headlamp
housing (material PC) painted in a
specialist paint shop.