Cambridge Audio INCOGNITO LK10 - Manual (Page 10)

The LK10 can only be used to control source equipment once it has been
cloned from the LR10. This transfers the necessary IR codes and macros
into the LK10. The Incognito LR10 is a sophisticated learning remote which
is able to learn the codes of all the source equipment from their own
remotes.
Once the LR10 itself has been programmed the user can clone all macros
and programmed information from the LR10 to the LK10, allowing the
keypad to also perform the same operations (IR codes, macros, button
names and clock settings).
Note: Only the learning buttons highlighted on the remote are cloned to the
LK10.
Please refer to the LR10’s own manual for full details on how to teach codes into
the LR10, advice on macros etc. Once the LR10 is fully programmed/setup, you
can clone it into the LK10.
To begin cloning, plug the supplied connection cable into the cloning port on the
LK10 and LR10, then put the LK10 into Learn mode.
Set the LR10 to transmit (the LK1O will default to
Receiving mode).
On the back of the LR10 press the Edit button 4
times (using a paperclip or similar) to enter Clone
mode. ‘REC/TRX’ will appear on both displays.
10
Cloning from the remote control
(Set) Menu Title Exit
Fav-1 Shift