Jeppesen FliteDeck Pro (iOS) - Manual (Page 15)

Getting Started
FliteDeck Pro Global Settings
Jeppesen FliteDeck Pro User Guide October 2014
Copyright © 2014 Jeppesen. All rights reserved.
8
Flight Info
This setting enables the sharing of flight information between two
iPads actively running FliteDeck Pro. The setting is ON by
default.
To share flight information, ensure that Allow Flight Sharing is
set to ON for both iPads. In addition, ensure that Airplane mode
is disabled and that either a Wi-Fi connection is established, or
Bluetooth is set to ON for both iPads.
Enroute View
These settings control the display of the Enroute view. Both
Enroute View settings are set to OFF by default.
• Switch Enable Moving Map to ON to be able to track your
aircraft, recenter the enroute map over your aircraft
location, and view the enroute map in Track Up orientation.
• Switch Display Ownship on Enroute to ON to display
ownship position on the enroute map.
The minimum GPS accuracy requirement to display
ownship on an enroute map is 200 meters.
NOTE Centering the map over aircraft location and displaying
the ownship position symbol on the enroute map are both
designed to improve flight crew situational awareness during
enroute flight. This function is not to be used as the basis for
navigation.
Appropriate flight crew member training and procedures
emphasize set up and operation such that the display should
not become a distraction or increase heads down time.
Operators may require additional authorizations to use this
function.