Jeppesen FliteDeck Pro (iOS) - Manual (Page 50)

Accessing Terminal Chart Information
Rotate a Chart
October 2014 Jeppesen FliteDeck Pro User Guide
Copyright © 2014 Jeppesen. All rights reserved.
43
Rotate a Chart
To rotate a terminal chart, tap the Rotate button. Each time that
you tap the Rotate button, the chart turns 90 degrees clockwise.
NOTE The rotated view does not accompany a chart that is
shared between devices.
Display Ownship on the Airport Diagram
Ownship position appears on the airport diagram when Display
Ownship on Airport Diagram is set to ON, and your aircraft is
moving no faster than the speed specified for the Arpt Diagram
(10-9) Speed Threshold in global settings. The speed threshold
is 40 knots by default.
Automatic Display of the Taxi Diagram upon Landing
To automatically switch to the taxi diagram for the airport where
you are landing, tap the Settings button on the FliteDeck Pro
toolbar. Switch Show Taxi On Landing to ON. The setting is
OFF by default.The speed threshold is 40 knots by default.
NOTE The automatic display of a taxi diagram is based on the
speed threshold that is specified for the Arpt Diagram (10-9)
Speed Threshold in global settings. A GPS signal is required
for the automatic switch to a taxi diagram.