Lock or unlock the liftgate, Engine starting/stopping, Getting started – Dodge 2012 Journey - User Guide User Manual

Page 12

Advertising
background image

Press” and “Unlock All Doors 1st Press”, refer to the Uconnect Touch™ Settings in
your vehicle's Owner's Manual on the DVD or Programmable Features in this guide for
further information.

• If “Unlock All Doors 1st Press” is programmed all doors and liftgate will unlock when

you press the liftgate button. If “Unlock Driver Door 1st Press” is programmed only
the liftgate will unlock when you press the liftgate button. To select between “Unlock
Driver Door 1st Press” and “Unlock All Doors 1st Press”, refer to the Uconnect
Touch™ Settings in your vehicle's Owner's Manual on the DVD or Programmable
Features in this guide for further information.

• If a Key Fob is detected in the vehicle when locking the vehicle using the power door

lock switch, the doors and liftgate will unlock and the horn will chirp three times. On
the third attempt, your Key Fob can be locked inside the vehicle.

• After pressing the Keyless Enter-N-Go LOCK button, you must wait 2 seconds before

you can lock or unlock the vehicle using the door handle. This is done to allow you to
check if the vehicle is locked by pulling the door handle, without the vehicle reacting
and unlocking.

• If a Keyless Enter-N-Go door handle has not been used for 72 hours, the Keyless

Enter-N-Go feature for that handle may time out. Pulling the deactivated front door
handle will reactivate the door handle's Keyless Enter-N-Go feature.

Lock or Unlock the Liftgate:

• With a valid Keyless Enter-N-Go Key

Fob within 3 ft (1.0m) of the liftgate,
press the button located to the left of
the liftgate handle to unlock the
liftgate. Press the button a second
time to lock the liftgate.

NOTE:
• Refer to your Owner's Manual on the DVD

for further information.

Engine Starting/Stopping

Starting

• With a valid Keyless Enter-N-Go Key

Fob inside the vehicle.

• Place the shift lever in PARK or

NEUTRAL.

• While pressing the brake pedal, press

the ENGINE START/STOP button once.
If the engine fails to start, the starter
will disengage automatically after
10 seconds.

GETTING STARTED

10

Advertising