Dodge 2013 Dart - User Guide - Manual (Page 69)

Send Messages Using Voice Commands:
• Press the Uconnect® Phone button,
• After the “Listening” prompt and the following beep, say “Send message to John Smith
mobile”,
• After the system prompts you for what message you want to send, say the message you
wish to send or say “List”. There are 18 preset messages.
• While the list of defined messages are being read, you can interrupt the system by
pressing the button and saying the message you want to send.
• After the system confirms that you want to send your message to John Smith, your
message will be sent.
List of Preset Messages
Yes. I will be <number> minutes late
No. See you in <number> minutes.
Okay. Stuck in traffic.
I can't talk right now. Start without me.
Call me. Where are you?
I'll call you later. Are you there yet?
I'm on my way. I need directions.
Thanks. I'm lost.
I'll be late. See you later.
Uconnect® Voice Command
• If the Uconnect® Voice Command button exists on your steering wheel, then you
have the Voice Command feature.
• The Voice Command feature lets you keep your hands on the steering wheel, and your
eyes on the road.
• When you press the Voice Command button located on the radio faceplate or
steering wheel, you will hear a beep. The beep is your signal to give a command. If you do
not know what commands to say, you can say "help" and the system will provide options
to you. If you ever wish to interrupt the system while it lists options, press the Voice
Command button
, listen for the BEEP, and say your command.
ELECTRONICS
67