Canon PIXMA MP830 - Manual (Page 135)

Chapter 8
Chapter 8 133 Reading from and Writing to a Memory Card
Reading from and Writing to a Memory
Card
Setting up the Card Slot as the Memory Card Drive of
the Computer
The Card Slot of the machine can also be used as the memory card drive of the computer.
1
Display the Read/write attribute screen.
(1) Ensure that the memory card is not set.
If the memory card is set, remove it from the Card Slot. See “Inserting the Memory Card”
on page 54 .
(2) Press [Menu].
(3) Use [ ] or [ ] to select <Maintenance/settings> and then press [OK].
(4) Use [ ] or [ ] to select <Device settings> and then press [OK].
(5) Use [ ] or [ ] to select <Other settings> and then press [OK].
(6) Use [ ] or [ ] to select <Read/write attribute> and then press [OK].
2
Specify the Read/write attribute.
(1) Use [ ] or [ ] to specify <Read/write attribute>.
(2) Press [OK].
Important
When <Read/write attribute> under <Device settings> is set to <Read/write mode> using the
Operation Panel of the machine, card direct printing cannot be done. After using the Card Slot as the
memory card drive of the computer, remove the memory card, then be sure to set <Read/write
attribute> to <Read-only mode>.
Read-only mode: The Card Slot is used only for reading. Be sure to select this
mode when printing photos from a memory card.
Read/write mode: The Card Slot is used as the memory card drive of the
computer. Photo data can be written into the memory card.
Note
When using the Card Slot as the memory card drive of the computer, the removal operation
from the computer is needed before removing the memory card from the machine.
Right-click the removable disk icon and click [Eject]. If [Eject] is not displayed on the screen,
ensure that the Access Lamp is not flashing and remove the memory card.
Be sure to drag the icon into the Trash.