Baumer PA210 - Manual (Page 15)

PA210
www.baumer.com 15
3 Connection
This chapter is about terminal assignment and will present some
wiring examples.
3.1 Terminal assignment


P$


Litz contact only by means of connector sleeves with insulating
enclosures for reasons of shock protection according to EN 61010.
Do not otherwise assign contacts that have been left unassigned ex
factory. We recommend to screen all sensor terminal leads and to
ground the shield on one side. Shields on both sides are recommen-
ded in case of RF interference or in case of equipotential bonding
over long distances. The sensor leads should not be in the same
phase winding as the mains supply and the output contact leads.
3.2 Inputs and outputs
Signal Resolution Input resistance
4...20 mA 0.01 mA 10 Ω
3.3 Voltage supply connection
Device supply is via 4…20 mA current loop.
3.4 Wiring examples

P$
 
$FWLYHFXUUHQWORRS
P$