Baumer BA DenexMicro - Manual (Page 13)

User Manual DENEX MICRO 13/24 Baumer Electric AG
Version 2013-02, V1.6 www.baumer.com Frauenfeld, Switzerland
6.4 DIP-Switch Settings
An 8-pole DIP-switch can be reached via the lid on top of the sensor. Unscrewing the
screw opens the lid.
The software functions can be controlled via the DIP switches.
DIP-Switch positions
= OFF
= ON
DIP-switches 1-4 are reserved for factory
DIP-switches 5-8 are for selecting operation mode
All in OFF-position is the default setting.
DIP-Switches
5 6 7 8
Mode 0 =
Default Counting mode: 15% Blocking, short Back-Edge Check, Output 5ms
Mode 1 Thick newspapers: 30% Blocking time, long Back-Edge Check. Output 5 ms
Mode 2 Counting mode: speed pulses, Blocking pulses 5, Back-edge 16, Output: 5ms
Mode 3 Counting mode: speed pulses, Blocking pulses 5, Back-edge 5,Output: 20ms
Mode 4 Thick newspapers, Blocking pulses 20. Back-edge 16, Output: 5ms
Mode 5 Edge detecting: fixed trig, Blocking 15%,No back-edge check, Output: 5ms
Mode 6 Gripper Pulse mode: For gripper conveyors, Blocking 15%, Output 20 ms
Mode 7 Cut edge first mode: Blocking 30 %, Back-edge 15%, Output 5 ms
Mode 8 Counting mode: Speed pulses, Blocking 10, Back-edge 16, Output 5ms
Mode 9 Commercial: Fixed trig, No Blocking, No Back-edge, Output 20 ms
Mode 10 Counting mode: 15% Blocking, short Back-Edge Check, Output 20ms
Mode 11 Counting mode: speed pulses, Blocking pulses 5, Back-edge 16, Output: 5ms
Laser power save mode is activated in all Counting/newspaper modes.
This means the laser power will be reduced after a 60 seconds gap.