Baumer FHDx14 IO - Manual (Page 3)

en_BA_FNDx14_FHDx14_IO.doc 3/14 Baumer Electric AG
12.04.2013/hem Frauenfeld, Switzerland
1 General information
1.1 Concerning the contents of this document
This manual contains information regarding the commissioning and communication of Baumer series 14
photoelectric diffuse sensors with SmartReflect and background suppression with the IO-Link interface. It is a
supplement to the mounting instructions supplied with each sensor.
This manual applies to the following sensor types:
Diffuse sensors with SmartReflect technology
FNDH 14G6901/IO
FNDH 14G6901/KS34A/IO
FNDR 14G6901/S14/IO
FNDK 14G6904/IO
FNDK 14G6904/S35A/IO
FNDK 14G6904/S14/IO
Diffuse sensors with background suppression
FHDH 14G6901/IO
FHDH 14G6901/KS34A/IO
FHDR 14G6901/S14/IO
1.2 General information
Intended
use This product is a precision device and is used for object detection and the
preparation and/or provision of values as electrical quantities for a subsequent
system.
Unless this product is specially labeled, it may not be used for operation in
potentially explosive environments.
Commissioning Installation, mounting and adjustment of this product may be performed only by a
qualified person.
Mounting For mounting, use only the mechanical mountings and mechanical mounting
accessories intended for this product.
Unused outputs must not be wired. In cable versions with unused cores, these cores
must be insulated. Do not exceed admissible cable bending radii. Prior to electrical
connection of the product, the system must be disconnected from the power supply.
In areas where screened cables are mandatory, they must be used as protection
against electromagnetic disturbances. If plug connections to screened cables are
made by the customer, an EMC version of the connectors should be used, and the
screen must be connected to the connector housing across a large area.