CDA CYLINDER EXTRACTORS EVCK4 - Manual (Page 11)

10
Mounting your extractor
IMPORTANT NOTE:
The extractor is now mounted and secured to the
wall; the electrical connections are now required to be
made in order for the extractor to function.
1. Ensure that there are no trapped wires - The mains lead
and control wires are easily trapped when securing the
stainless section to the motor.
2. Locate the main terminal box (on the left as you look
at it) and remove the 2 screws, shown as D on the
diagram below. Connect the main connector plug
(Shown as B in the diagram) and replace the cover.
3. Locate the control terminal box (on the right) and
remove the 2 screws. Connect the connector as shown in
the diagram (A) and refit the terminal cover.
Fig. 16