Changing the filter, More about your advanced water filter, Test & certification results – FRIGIDAIRE FGUS2647LF User Manual

Page 21: Water filter

Advertising
background image

21

CHANGING THE FILTER

More about your Advanced

Water Filter

The PureSource Ultra

TM

ice and water filter system is

tested and certified by NSF

International, to NSF/ANSI

Standards 42 and 53 for the

reduction of claims specified on

the performance data sheet.

Do not use with water that is microbiologically

unsafe or of unknown quality without adequate

disinfection before or after the system.

Systems certified for cyst reduction may be

used on disinfected waters that may contain

filterable cysts.

Test & certification results:

• Rated Capacity - 200 gallons/757 liters for

PureSource Ultra

TM

ice and water filter

• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per

square inch

• Recommended Minimum Operating

Pressure: 30 pounds per square inch

To replace your PureSource

Ultra

TM

water filter:

It is not necessary to turn the water supply off

to change the filter. Be ready to wipe up any

small amounts of water released during the

filter replacement.
1 Turn Off the ice maker.
2 Remove the filter by pushing on the end/

face of the filter.

3 Slide the old water filter cartridge straight

out of the housing and discard it.

4 Unpackage the new filter cartridge. Using

the alignment guide, slide it gently into

the filter housing until it stops against

the snap-in connector at the back of the

housing.

5 Push firmly until the cartridge snaps

into place (you should hear a click

as the cartridge engages the snap-in

connector).

6 Press a drinking glass against the water

dispenser while checking for any leaks at

the filter housing. Any spurts and sputters

that occur as the system purges air out of

the dispenser system are normal.

7 After filling one glass of water, continue

flushing the system for about three

minutes.

8 Turn On the ice maker.
9 Press and hold the Filter Status button

on the Ice & Water Dispenser control

panel for three seconds. When the display

changes from “Replace” to “Good,” the

status has been reset.

Advertising