FRIGIDAIRE FGUS2647LF - Manual (Page 5)


NOTE
If your refrigerator is placed with the door hinge side against a wall, you may have to allow
additional space so the door can be opened wider.
5
INSTALLATION
CAUTION
Do Not install the refrigerator where the
temperature will drop below 55°F (13°C) or
rise above 110°F (43°C). The compressor will
not be able to maintain proper temperatures
inside the refrigerator.
Do Not block the toe grille on the lower front of
your refrigerator. Sufficient air circulation is essential
for the proper operation of your refrigerator.
This Use & Care Guide provides general
operating instructions for your model. Use the
refrigerator only as instructed in this Use & Care
Guide. Before starting the refrigerator,
follow these important first steps.
Location
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• If possible, place the refrigerator out of
direct sunlight and away from the range,
dishwasher or other heat sources.
• The refrigerator must be installed on a floor
that is level and strong enough to support a
fully loaded refrigerator.
• Consider water supply availability for models
equipped with an automatic ice maker. If
you do not hook up water to the refrigerator,
remember to turn the ice maker off.
Toe Grille Installation and Removal
To install toe grille
1 Open both doors.
Slide left and right
sides of toe grille
over lower hinges
of refrigerator.
2 While pushing
toe grille firmly
against cabinet,
fasten bottom
clips of toe grille
to cabinet.
3 Fasten top clips to
cabinet.
4 Close the doors. Fasten right and left side clips into groove of bottom hinge.
To remove toe grille
1 With both doors
closed, unfasten
right and left side
clips of toe grille
from bottom hinge
groove.
2 Open both doors.
Press firmly on top
of toe grille until
top of toe grille
pops off.
3 Pull toe grille
outward toward
your body and off
of lower hinges.
Installing Toe Grille
Removing Toe Grille
Installation
Installation clearances
• Allow the following clearances for ease
of installation, proper air circulation, and
plumbing and electrical connections:
Sides & Top 3 /
8
inch
Back 1 inch