FRIGIDAIRE FGMC2765PB - Manual (Page 26)

26
SETTING OVEN CONTROLS
MINIMUM AND MAXIMUM CONTROL PAD SETTINGS
All of the features listed below have minimum and maximum time or temperature settings that may be entered into the
control. An ENTRY acceptance beep will sound each time a control pad is touched (the acceptance beep on the Oven
Lockout pad is delayed 3 seconds).
An ENTRY ERROR tone (3 short beeps) will sound if the entry of the temperature or time is below the minimum or above
the maximum settings for the feature.
FEATURE MINIMUM TEMP. /TIME MAXIMUM TEMP. /TIME
PREHEAT 170°F/77°C 550°F/288°C
BAKE 170°F/77°C 550°F/288°C
BROIL 400°F/205°C 550°F/288°C
CONVECTION BAKE 170°F/77°C 550°F/288°C
CONVECTION ROAST 170°F/77°C 550°F/288°C
CONVECTION BROIL 400°F/205°C 550°F/288°C
SLOW COOK Lo (225°F/108°C) Hi (275°F/135°C)
PROBE 140°F/60°C 210°F/99°C
TIMER 12 Hr. Mode 0:01 Min. 11:59 Hr./Min.
24 Hr. Mode 0:01 Min. 11:59 Hr./Min.
CLOCK TIME 12 Hr. Mode 1:00 Hr./Min. 12:59 Hr./Min.
24 Hr. Mode 0:00 Hr./Min. 23:59 Hr./Min.
DELAY START 12 Hr. Mode 1:00 Hr./Min. 12:59 Hr./Min.
24 Hr. Mode 0:00 Hr./Min. 23:59 Hr./Min.
BAKE TIME 12 Hr. Mode 0:01 Min. 6:00 Hr./Min.
24 Hr. Mode 0:01 Min. 6:00 Hr./Min.
SELF CLEAN TIME 2 hours 4 hours
SETTING THE CLOCK
The SET CLOCK pad is used to set the clock. The clock may
be set for 12 or 24 hour time of day operation. The clock
has been preset at the factory for the 12 hour operation.
When the range is fi rst plugged in, or when the power
supply to the range has been interrupted, the timer in the
display will fl ash.
To set the clock (example below for 1:30)
1. Press SET CLOCK. "CLO" will appear in the display.
2. Press 1 3 0 pads to set the time of day to 1:30. "CLO"
will stay in the display.
3. Press START. "CLO" will disappear and the clock will
start.
CHANGING BETWEEN 12 OR 24 HOUR TIME
OF DAY DISPLAY
1. Press and hold SET CLOCK for 6 seconds. "CLO" will
appear in the display.
2. CONTINUE holding the pad until "12Hr dAY" or "24Hr
dAY" appears in the display and the control beeps
once.
3. Press SELF CLEAN to switch between the 12 and 24
hour time of day display. The display will show either
"12Hr dAY" or "24Hr dAY".
4. Press START to accept the change or press OFF to reject
the change.
5. Reset the correct time as described in To set the Clock
above. Please note that if the 24 hour time of day mode
was chosen, the clock will now display time from 0:00
through 23:59 hours.