FRIGIDAIRE FGMC2765PB - Manual (Page 45)

45
CARE & CLEANING
CAUTION
The door is heavy. For safe, temporary storage, lay the
door fl at with the inside of the door facing down.
CAUTION
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn the oven
light on during a self-cleaning cycle. High temperature
will reduce lamp life.
REMOVING AND REPLACING THE LIFT-
OFF OVEN DOOR
To Remove Oven Door:
1. Open oven door completely (horizontal with fl oor-
See Figure 1).
2. Pull the door hinge locks on both left and right
door hinges down from the oven frame completely
towards the oven door (See Figure 2). A tool such as
a small fl at-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle- See Figure 3).
4. Close the door to the broil stop position (the oven
door will stop into this position just before fully
closing).
5. With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 4).
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle- See Figure 3).
2. Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm over
the roller pins located on each side of the oven door
frame (See Figure 4). The hook of the hinge arms
must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with fl oor- See
Figure 1).
4. Push the door hinge locks up towards and into the
oven frame on both left and right oven door hinges
(See Figure 2) to the locked position.
5. Close the oven door.
Door Hinge locations with
oven door fully open
Figure 1 Figure 2
Figure 3 Figure 4
Oven door
Around
Hinge
Special Door Care Instructions - Most oven doors
contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks
are fully in place.
2. Do not hit the glass with pots, pans, or any other
object.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
CHANGING OVEN LIGHT
The oven light bulbs are located at the rear of the oven
cavity and are covered with a glass shield. The glass
shield must be in place whenever the oven is in use.
To Replace the Light Bulb:
1. Turn electrical power off at the main source or unplug
the appliance.
2. Remove lower oven interior light shield by turning a
quarter turn counter-clockwise.
3. Replace bulb with a new T-4 type 40 Watt Halogen
appliance bulb.
Please note: do not allow your fi ngers to touch the new
bulb when replacing. This will shorten the life of the new
bulb. Use a paper towel to cover the new bulb when
installing.
4. Replace glass shield
over bulb by rotating
clockwise.
5. Turn power back on
again at the main
source (or plug the
appliance back in).
6. The clock will then
need to be reset.
LOCK