FRIGIDAIRE FFTR1022QW - Manual (Page 7)

7
Cleaning
• Wash any removable parts of the refrigerator interior,
and exterior with mild detergent and warm water. Wipe
dry. Do not use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp instruments,
which can scratch the appliance surface when removing
adhesive labels. Any glue left from the tape can be
removed with a mixture of warm water and mild
detergent, or touch the residue with the sticky side of
tape already removed. Do not remove the serial plate.
• Install the refrigerator in the coolest part of a dry and
ventilated room, out of direct sunlight and away from
heating ducts or registers. Do not place the refrigerator
next to heat-producing appliances such as a range,
oven or dishwasher.
• Level the refrigerator so the doors close tightly.
• Do not overcrowd the refrigerator or block cold air
vents. Doing so causes the refrigerator to run longer
and use more energy. Shelves should not be lined
with aluminum foil, wax paper or paper toweling.
Liners interfere with cold air circulation, making the
• Wipe bottles and containers dry before placing them in
the refrigerator. This cuts down on moisture build-up
inside the unit.
• Organize the refrigerator to reduce door openings.
Remove as many items as needed at one time and
close the door as soon as possible.
CAUTI ON
To allow door to close and seal properly, DO NOT let
food packages extend past the front of shelves.
Shelf Front
ENERGY SAVI NG TI PS TEMPERATURE CONTROLS
Cool Dow n Period
For best performance, allow four hours for the refrigerator to
cool down completely. The refrigerator will run continuously
Temperat ure Cont rol
To adjust the temperature colder in the refrigerator
compartment, press the SET button on the control panel so
that the display light shifts to a higher number. “1” is the
warmest setting and “5” is the coldest. To adjust the
temperature colder in the freezer compartment, move the
Freezer Control knob towards the maximum setting. After
each movement of either control, allow 24 hours for the unit
to adjust. If the unit is still not cold enough, repeat until
desired temperature is achieved.
To adjust the temperature warmer in the refrigerator
compartment, press the SET button on the control panel so
that the display light shifts to a lower number. To adjust the
temperature warmer in the freezer compartment, move the
Freezer Control knob towards the minimum setting. After
each movement of either control, allow 24 hours for the
unit to adjust. If the unit is still not warm enough, repeat
until desired temperature is achieved.
If more than one of the display windows remain lit at the
same time, call the 1-800 number on the cover of this
manual for service since this indicates a fault with the
control system.
The temperature control is located inside the refrigerator
and in the freezer compartment on some models. The
temperature is factory preset to provide satisfactory food
storage temperatures. However, the temperature control
is adjustable to provide a range of temperatures for your
personal satisfaction.
Freezer Cont rol
Temperat ure Cont rol Panel