FRIGIDAIRE FGDS3065PF - Manual (Page 34)

34
OVEN CONTROLS
Restoring Factory Default Setting
Your appliance is programmed with default control settings.
Over time, users may make changes to these settings. The
following options have settings that can be modified and
may have been changed since the appliance was new:
• 12 or 24 hour display mode
• Continuous bake or 6 hour energy savings mode
• Silent or audible control
• Oven temperature display (°F or °C)
• Oven temperature adjustments (offsets)
• Stored recipes
• Cancel/continue cooking with meat probe option.
To restore oven control to factory default settings:
1. When the oven is in idle and no cooking function is in
operation, press and hold the 7 key until the acceptance
tone sounds (about 6 seconds)
2. Press start. The control is now reset to default settings.
Adjusting Oven Temperature
The temperature in the oven is pre-set at the factory. When
first using the oven, be sure to follow recipe times and
temperatures. Do not use oven thermometers such as
those should in grocery stores to check the temperature
settings inside the oven. These thermometers may display
temperatures that vary widely from the actual temperature.
If you think the oven is cooking too hot or too cool for the
temperature you select, you can adjust the actual oven
temperature to be more or less than what is displayed.
Before adjusting, test a recipe by using a temperature
setting higher or lower than the recommended temperature.
The baking results should help you to decide how much of
an adjustment is needed.
To adjust the oven temperature higher:
1. Press bake for 6 seconds. UPO 0 will appear in the
display.
2. To increase the temperature, use the number keys to
enter the desired change. For example, for 30°F, press
3 0. The temperature may be increased as much as
35°F (19°C).
3. Press start to accept the temperature change and the
display will return to the time of day. Press off to reject
the change if necessary.
To adjust the oven temperature lower:
1. Press bake for 6 seconds. The display will show.UPO 0.
2. To decrease the temperature, use the number keys to
enter the desired change (Example -30°F) 3 0. Then,
press self clean. The temperature may be decreased
as much as 35°F (19°C).
3. Press start to accept the temperature change and the
display will return to the time of day. Press off to reject
the change if necessary.
If you choose to restore factory default settings, all of the
above user preferences will be restored to their original
settings (factory default). The oven temperature offset will
reset, and any stored recipes will be cleared.
NOTE
The oven temperature adjustments made with this feature
will not change the self clean cycle temperature or the
broil temperature.The oven temperature adjustments are
permanent and will stay in the unit memory unless you
manually change it again or if all the controls are reset.
Even a power outage will not reset these changes. Follow
the same procedure again if you wish to change it to a
different setting or use the
“Restoring Factory Default
Setting” instructions on page 34 to restore settings to
their defaults.
NOTE