Acronis Access Advanced - Installation Guide - Manual (Page 160)

160 Copyright © Acronis International GmbH, 2002-2014
Note: The port 443 is the default port. If you have changed the default port, add your port number after
localhost.
3. Write down the Administration Key.
4. Open the Acronis Access Web Interface.
5. Open the Mobile Access tab.
6. Open the Gateway Servers page.
7. Press the Add New Gateway Server button.
8. Enter a Display Name for your Gateway Server.
9. Enter the DNS name or IP address of your Gateway Server.
Note: If your mobile clients connect to the gateway by going through a reverse proxy server or
loadbalancer you should enable Use alternate address for client connections and enter the DNS name or IP
address of your reverse proxy server or loadbalancer.
10. Enter the Administration Key.
11. If required, allow connections with self-signed certificates to this gateway by enabling Allow
connections from Acronis Access servers using self-signed certificates.
12. Press the Save button.
Note: Make sure you have at least 1 Gateway Server available.