FRIGIDAIRE FPEF4085KF - Manual (Page 31)

31
CARE & CLEANING
CAUTION
Be sure the oven is unplugged and all parts are COOL
before replacing the oven light bulb. Do not turn
the oven light ON during a self-cleaning cycle. High
temperature will reduce lamp life.
CAUTION
BE SURE OVEN IS COOL
Special door care instructions - Most oven
doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are
fully in place.
2. Do not hit the glass with pots, pans, or any other
object.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
Changing oven light
The interior oven light will turn ON automatically when
the oven is opened. The oven light may be turned ON
when the door is closed by using the oven light switch
located on the Electronic Oven control. The oven light
bulb is covered with a glass shield held in place by a wire
holder. THIS GLASS SHIELD MUST ALWAYS BE IN PLACE
WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
1. Turn the power OFF at the main source.
2. Wear a leather-faced glove for protection against
possible broken glass.
3. Replace bulb with a 40 Watts appliance bulb only.
4. Press wire holder to one side to release glass shield,
change bulb and be sure to replace glass shield.
CAUTION
The door is heavy. After removing door, lay it fl at on
the fl oor with its inside facing down.
Removing and Replacing the main oven
door (If equipped with hinge style B)
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and
engage it in the hinge levers. You may have to apply
a little downward pressure on the door to pull the
locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the
door up and toward you to disengage the hinge
supports. Keep pulling the bottom of the door toward
you while rotating the top of the door toward the
range to completely disengage the hinge levers.
4. To replace the door, reverse the door removal steps.
Make sure the hinge supports are fully engaged
before unlocking the hinge levers.
Lock in normal
position
Lock engaged
for door removal
Hinge slot door removed
from the range