FRIGIDAIRE FGEF302TNF - Manual (Page 21)

21
SETTING OVEN CONTROLS
How the Electronic Surface Element Controls
work when the Sabbath feature is ON.
When your Oven Sabbath feature is ON, the Electronic
Surface Elements are also in Sabbath mode. This means
that all electronic surface element control displays show
"Sb". The surface elements can be used even if the
Sabbath Feature is on.
To turn ON a Surface Element when the Oven
Sabbath Feature is active:
If you turn on a surface element when the oven Sabbath
feature is on, the electronic surface element control will
record that request and execute it with a 15-30 seconds
delay. So the element will start heating 15-30 seconds
after the surface element control was turned on. As the
oven control, the surface element display will not show the
setting because "Sb" is on in the displays. When necessary,
it is possible to adjust the power of the surface element but
you have to remember that the surface element control will
adjust the temperature with the same delay.
To turn OFF the Surface Element when the Oven
Sabbath Mode is active:
To shut off the surface element while the Sabbath feature
is ON, proceed as usual but take note that the element will
immediately turn off without any delay.
SETTING THE SABBATH FEATURE (for use on
the Jewish Sabbath & Holidays)
The BAKE TIME and DELAY START pads are used to
set the Sabbath feature. The Sabbath feature may only be
used with the BAKE pad. The oven temperature may be
set higher or lower after setting the Sabbath feature (the
oven temperature adjustment feature should be used only
during Jewish Holidays), however the display will not visibly
show or provide any audible tones indicating whether the
change occurred correctly. Once the oven is properly set
using Bake with the Sabbath feature active, the oven will
remain continuously ON until CLEARled. This will override
the factory preset 6-Hour Energy Saving feature.
If the oven light will be needed during the Sabbath, press
OVEN LIGHT before activating the Sabbath feature.
Once the oven light is turned ON and the Sabbath feature
is active, the oven light will remain ON until the Sabbath
feature is turned OFF. If the oven light needs to be OFF,
be sure to turn the oven light OFF before activating the
Sabbath feature.
To Program the Oven to Begin Baking Immediately &
activate the Sabbath feature (example: baking at 350°F)
1. Be sure that the clock is set with the correct time of day.
2. Place the food in the oven.
3. Press UPPER OVEN or LOWER OVEN to select oven.
4. Press BAKE. "350°" appears in the display.
5. Press START. The actual oven temperature appears in
the display.
6. If you desire to set the oven control for a Bake Time or
Delayed Bake Time do so at this time. If not, skip this
step and continue to step 8. Refer to the Bake Time /
Delay Start section for complete instructions. Remember
the oven will shut down after using Bake Time or Delay
Start and therefore may only be used once during the
Sabbath/Jewish Holidays. The maximum Delayed Start
Bake time is 11 hours & 59 minutes.
7. The oven will turn ON and begin heating.
8. Press and hold both the BAKE TIME and DELAY START
pads for at least 3 seconds. "SAb" will appear in the
display. Once "SAb" appears in the display the oven
control will no longer beep or display any further changes
and the oven is properly set for the Sabbath feature.
9. The oven may be turned OFF at any time by fi rst pressing
CLEAR pad (this will turn the oven OFF only). To turn OFF
the Sabbath feature press and hold both the BAKE TIME
and DELAY START pads for at least 3 seconds. "SAb"
will disappear from the display.
IMPORTANT
It is not advised to attempt to activate any other program
feature other than BAKE while the Sabbath feature is
active. ONLY the following key pads will function after
setting the Sabbath feature; 0 to 9, BAKE, START &
CLEAR. All other keypads should not be used once
the Sabbath feature is properly activated.
Í NOTE
You may change the oven temperature once baking has
started by pressing BAKE, the numeric key pads for the
temperature you want (example for 425°C press 4 2 5)
and then pressing START twice (for Jewish Holidays
only). Remember that the oven control will no longer
beep or display any further changes once the oven
is set for the Sabbath feature.
Should you experience a power failure or interruption,
the oven will shut off. When power is returned, "SF"
(Sabbath Failure) will be shown in the oven display and the
cooktop displays. The oven and cooktop will not turn back
on automatically. If your food was nearly fully cooked,
you may allow the trapped heat in the oven to fi nish the
cooking process. Otherwise, you should remove the food
when the power failure occurs, because you may only start
the oven once during the Sabbath/Jewish Holidays. After
the Sabbath observance turn OFF the Sabbath feature and
the oven may be used with all normal functions.
After the Sabbath observance turn OFF the Sabbath
feature. Press and hold both the BAKE TIME and DELAY
pads for at least 3 seconds. "SAb" will disappear from
the display and the oven may be used with all normal
functions. For further assistance, guidelines for proper
usage, and a complete list of models with the Sabbath
feature, please visit the web at http:\\www.star-k.org.