FRIGIDAIRE FHPC4260LS - Manual (Page 13)

13
Technical data
Power supply : 120V~, 60Hz
Power consumption : 520W
Bulb type : 4 x 20W, 120V~
(type: GU10)
Power cable type : 18AWG
(Amer. Wire Gauge)
300V~, 105˚C
Troubleshooting
Problem Cause Solution
Excessive
vibration.
The appliance
is not fixed
properly on the
brackets. Take down
the appliance
and check it is
properly fixed.
The fan blade
is damaged.
Switch off the
appliance.
Repair to be
carried out by
qualified service
personnel only.
The fan motor
is not fixed
tightly.
Light on, but
fan does not
work.
The fan blade
is jammed.
The motor is
damaged.
Both light and
fan do not
work.
Light bulb
broken.
Replace with
a bulb with
correct rating.
Problem with
electrical
connection
Check the
electrical
connection with
an electrician.
Suction
performance
is not good.
Distance
between the
appliance and
the cooking
place too
large.
Readjust the
distance (see
fig. on
page 6).
Metallic anti-
grease filter is
dirty.
Clean
filters (see
Cleaning and
maintenance).
Environmental protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check
with your Local Authority or retailer for
recycling advice.
every 4 - 6 months
Charcoal filters:
• If the model is not vented to the outside, the
air will be recirculated through disposable
charcoal filters that help remove smoke
and odors.
• The charcoal filters cannot be cleaned,
they must be replaced regularly (depending
on range hood usage).
• NOTE: Do not rinse or put charcoal filters
in a dishwasher.
• NOTE: Charcoal filters are not included
with the range hood. Please call Frigidaire
at 1.800.944.9044 to order this kit. When
calling our customer service center, also
have this range hood’s model number
ready.
IMPORTANT
Clean the filter every month to prevent risk of fire.
Maintenance
• User servicing – Do not repair or replace
any part of the appliance unless specifically
recommended in the manual. All other servicing
should be referred to a qualified technician.
Light bulb replacement
• Switch the appliance off and disconnect the
power supply.
• In order to replace the light bulb (8), the metallic
anti-grease filter should be detached first.
• Pull the spring lock downward (fig. ).
• Rotate and pull one or both of the light bulbs from
the holders and replace with new light bulb(s) of
the same type (GU10, 20W, 120V~) (fig. / ).
• Replace the metallic anti-grease filter and make
sure it locks in place.
Troubleshooting