FRIGIDAIRE FGHD2465NB - Manual (Page 4)

4
DISHWASHER FEATURES
1. Load dishwasher (See Preparing and Loading
Dishes).
2. Add detergent (See Dishwasher Dispenser &
Detergents).
3. Add rinse aid (See Rinse Aid).
4. Select desired CYCLE (See Cycle Chart). The
indicator light above the pad will glow when selected.
5. Select desired OPTIONS (See Energy Options). The
indicator light above the pad will glow when selected.
NOTE
The dishwasher is programmed to remember your last cycle
so you do not have to reset each time. To start the
dishwasher using the same cycle and options selected on the
previous wash, just press the START/CANCEL pad.
Your dishwasher cleans by spraying a mixture of hot water and detergent through the spray arms against soiled surfaces.
Next, the dishwasher fills with water covering the filter area. Water is then pumped through the filter and spray arms. Soil
particles go down the drain as the water is pumped out and replaced with clean water. The number of water fills will vary
with the cycle being used.
Heating Element
Glass Trap
Self-Cleaning Filter
Rinse Aid
Dispenser
Upper Spray Arm
Tub Gasket
Middle Spray Arm
Orbit Clean TM
Spray Arm
Overfill Protector
Detergent Dispenser
Top Rack
Serial Label
(located on right
side of tub)
Bottom Rack
Silverware Basket
Removable
Versa-tray
Bowl Tines
Adjustable Upper Rack
Blower Vent
Assembly
Getting Started
6. Run hot water faucet nearest dishwasher until water is
hot. Turn water off.
7. To start, press START/CANCEL pad.
8. Close door to latch.
Vent