Cuisinart BFP-703 Series - Manual (Page 8)

• Don’t overprocess foods. Blender or
food processor will achieve most
desired results in seconds, not minutes.
• Don’t overload blender or food
processor. If the motor stalls, turn
OFF immediately, unplug the unit,
and remove a portion of the food;
then continue.
• Don’t use any utensil inside the
blender jar or food processor bowl
while the motor is ON.
• Don’t use any container or accessories
not recommended by Cuisinart. Doing
so may result in injury.
• Don’t place hands inside the blender
jar or food processor bowl when
blender is plugged in.
• Don’t add boiling liquids or frozen foods
(except ice cubes or 1/2" pieces of
frozen fruit) to glass blender
jar. Boiling liquids should cool for
5 minutes before being placed in
blender jar.
• The food processor accessory is not
intended to crush ice. This could
damage the chopping blade and will
damage work bowl.
FOOD PROCESSOR
FEATURES
AND BENEFITS
1. Food pusher with oil dispenser
2. Work bowl cover with feed tube
3. Stainless steel chopping blade
4. Stainless steel reversible slic-
ing/shredding disc
5. Adapter stem
6. Clear work bowl
7. Gearbox collar
8. Motor base
Used for both the blender jar and
the food processor bowl
FOOD PROCESSOR
STEP BY STEP
GETTING STARTED
Please note that the bowl with collar
will fit on the base in eight different
positions. The handle can be in front or
on either side and the feed tube in
front, back, or on either side. Directions
for use reference a certain position for
instructional purposes only.
FOOD PROCESSOR ASSEMBLY
FOR CHOPPING, PURÉEING & MIX-
ING
1. Hold gearbox collar in one hand
and work bowl handle in the other.
Twist bowl clockwise onto collar.
2. Place collar with bowl onto motor
base with handle facing front.
3. Place chopping blade over shaft in
work bowl. Chopping blade should
slide easily to the bottom of the
bowl. Lower blade will almost touch
bottom of bowl.
BE SURE TO HANDLE THE
METAL BLADE WITH CARE AS IT
IS RAZOR SHARP!
4. Place food to be processed in work
bowl. Put cover on work bowl, with
feed tube at about 11 o’clock.
Turn the cover clockwise until it fits
into position. Cover lock must click
into locked position prior to use. If
you have trouble fitting the cover on
the work bowl, turn chopping blade
hub slightly and replace cover.
Food Pusher with Oil Dispenser (1)
Work Bowl Cover with Feed Tube (2)
Reversible Slicing/
Shredding Disc (4)
Stainless Steel Chopping Blade (3)
Adapter Stem (5)
Work Bowl (6)
Gearbox Collar (7)
Blender Base (8)
6