FRIGIDAIRE FARE1011MW - Manual (Page 13)

13
OPERATING INSTRUCTIONS
Drying Rack (on select models)
Use the drying rack for items which should not be tumble
dried. Insert the rack into the dryer drum, resting the
back support on the moisture sensor bars and the front
legs on the air grill.
Place items to be dried on top of the rack, leaving space
between items and not allowing them to hang over the
sides or through the holes. The weight should not exceed
10 lbs (4.5 kg). Select the air dry (no heat) setting for
items containing plastic, foam rubber, rubber-like materi-
als, feathers or down.
When items are dry, remove the rack and store it in a
convenient location.
Other Features
Í NOTE
For step-by-step instructions on DOOR REVERSAL, refer to
the Installation Instructions supplied with this dryer.
Í NOTE
If your model did not come supplied from the factory
with a drying rack you may order one.
Estimated Time Remaining (on certain models)
The initial drying time will be displayed for about 5 min-
utes after the start of a cycle. Then in auto dry cycles,
the estimated drying time begins automatic time calcu-
lation throughout the cycle by the moisture sensors (if
equipped). Timed dry cycles continue with actual time
remaining.
Status Lights
The following indicators may be lighted during the cycle:
• clean lint fi lter
• drying
• cool down
• wrinkle release
• done
Drum Light
The drum light will come on whenever the door is opened
to illuminate the drum during loading and unloading.
Closing the door turns off the light.
Reversible Door
Your dryer is equipped with a reversible door. The door
can be hinged on the right or left side.
moisture sens-
ing bars
rear
support front
legs