FRIGIDAIRE FRA123KT1 - Manual (Page 4)

4
Installation Instructions
Choose the proper window location.
Choose a window that allows the cooled air to flow freely and directly
into room(s) you wish to cool. Remember, it is difficult to move air
around corners. Also, choose a window that is within 6 feet of an
electrical outlet as shown (FIG.5). (See Meeting Electrical
Requirements/Receptacle wiring needs.) Do not use an extension cord.
6 feet
power cord
reach
Attach support brace to platform as shown (FIG.6). Use adjustment
bolt and hex flange nut to complete assembly. Choose slot and adjustment
bolt hole locations that will create a 45 degree angle between platform and
support brace. Try assembly in the window to determine if platform will rest
SURSHUO\DQGDOORZSURSHUVORSH ƎORZHURQRXWVLGH 
NOTE:
If you are planning to use a siding-protection board (see Step 8)
on the outside of your house, hold board in place when testing
assembly in window.
NOTE:
,IDQ\VDVKVWRSSURWUXGHVPRUHWKDQƎIURPWKHVLGHZLQGRZ
MDPEVWKHƎPHDVXUHPHQWPXVWEHLQFUHDVHG
accordingly (FIG.7). Screen and storm window frames may also
require adjustments to the measurement.
Center platform assembly on the line with inside platform tab
pressed against inside edge of window track as shown (FIG.8A, FIG.8B).
8VLQJWKHKROHVLQWKHSODWIRUPDVDJXLGHPDUNDQGGULOOWZR ƎGLDPHWHU
holes. Drill holes in either track or stool.
Peel off protective backing from track seal. Apply seal to room side
of window track (FIG.9). Center of seal strip should coincide with the line
marked in Step 5. The two screw holes drilled in Step 6 should be directly
above seal strip in the inner track.
Inside wall
of house
Siding-protection
board
FIG.5
Platform Assembly
Ǝ PP +(;
FLANGE NUT
FIG.6
ƎLQFKHV FIG.7
FIG.8A
with platform tab pressed
against window track
Center platform
assembly on the line
window track window seal
Alternate screw location
(depending on the inner sill depth)
Platform tab FIG.8B
Apply track seal
to window side
of track.
FIG.9
FIG.10
3
4
0HDVXUHDQGOLJKWO\PDUNDOLQHƎIURPZLQGRZMDPE 5
6
7
Securely attach a siding-protection board to side of house (FIG.10).
127( Siding-protection board should be long enough to span 2 wall studs.
8
,QVWDOOLQJ8QLWLQD6OLGLQJ:LQGRZ